| Remove a leaf from a palm.|
Using a pin split the leaf in three, separating the hard center vein from the leaf at both sides. Leave the last 2cm intact at the side that was connected to the palm.
Carefully run your nail along the vein to soften it so that it’s more pliable. Fold the vein back on itself and tuck under the leaf where it’s still connected. It might be easier for you to use a tiny bit of putty or Oasis fix to keep the vein in place while you practice doing this and later you will find it’s easy to hold in place while you weave the body.
|Fold one side under and then over the vein. Pull tight. Do the same with the other side and pull tight.|
Continue weaving the body two or three more times depending on the length of your palm leaf.
|Create feelers (Antenna) by tucking the two sides of the leaf into the vein loop and pulling the vein snug. Separate the side strips and carefully run your nail through the length of each to curl as you would ribbon.|
Finish off the body by weaving the long center vein around itself and cut short. Cut the tail end if required.
|You can now add leaves for wings or cut the left-over vein in 2 for legs to tuck into the body.|